Tile Mate & Pro Case (2018, 2020) Assembly Guide

Tile Mate & Pro Case (2018, 2020) Assembly Guide

A classic, handcrafted fit for your Tile tracker.

Follow the visual guide above to secure your device. This model uses two small screws to lock the hardware onto the leather tab for maximum security.

Quick Assembly Steps

1. Insert: Slide your Tile device into the leather sleeve.

2. Position: Ensure the device is seated fully at the bottom so the protruding leather tab at the top is ready for the hardware.

3. Connect: Slide the metal hardware over the extended leather tab. Make sure the tab is centered and pushed deep into the hardware slot.

4. Fasten: Carefully insert the two small screws. As you tighten them, they will pierce and secure the leather tab within the hardware.

⚠️ Important Note: Hardware & Care

• Screwdriver Not Included: Please note that a precision screwdriver is not included in the package. You will need a small, properly sized screwdriver to complete the assembly.

• Prevent Scratches: Use a screwdriver that fits the screw head perfectly. Apply steady, downward pressure to prevent the driver from slipping, which could scratch the metal hardware or the premium leather.

• Check Firmness: Tighten both screws until they are flush with the hardware to ensure your Tile stays safely attached.